Code encryptor 2 installation

Press big blue keyfob button 3 times. Select free zone, program it for Panic After alarm panel and Code Encryptor are powered up, attach Gray wire to zone programmed for panic. Pressing Button 3 for 3 Seconds will cause the alarm to panic NOTE: If wire is connected before Code Encryptor powers up, a signal may be sent to alarm panel causing triggering of the panic mode on the zone selected. Location of the control module is the most important determining factor for range and.

Select a location that is as centrally located as pos-. Keep in mind that your customer will want to control the operation of the garage. Since the Code Encryptor uses the communication bus wires from the keypad, you may. Although you can wire at the panel, it may reduce labor by installing the Code.

Encryptor II receiver at the point of entry. In most cases that is the garage which will. Step 1 Unplug the receiver from the wire harness. Some panels may. Connect to Keypad Yellow. For Napco. NOTE: You can make these connections at the panel or at the keypad.

If you place the Code Encryptor II in the garage or any other. Encryptor II directly to the keypad. Step 3 Make sure the alarm panel is powered up and operating.

The corresponding flashes will indicate which panel the Code. You do not have to arm the alarm before you. We do however recommend that you Arm the alarm system. Test the System. Unplug the Receiver from the wire harness. NOTE: You can make these connections at the control or at the keypad itself. If you place the Code Encryptor 3 in the garage or any other location away from the control, you may choose to wire the Code Encryptor 3 directly to the keypad. Automatic Recognition 1. Make sure the alarm panel is powered up and operating.

The wire harness should still be disconnected from the Receiver. After about 2 seconds, count the flashes that you see. The corresponding flashes indicate which panel the Code Encryptor 3 has detected. Refer to the table below. Control Panel Detection Table No. Example: If you are using a Honeywell Vista P series control, no keypads can use address 17 because the CE 3 will automatically enroll itself as address This provides the system with a user code for arming and disarming of the control.

To program a user code into the Receiver, do the following: 1. Verify that the four-digit code you plan to teach the Code Encryptor 3 is a valid four-digit user code. Example: From the keypad use that four-digit code to arm the panel. If the panel arms, the code is good. If it does not, program that user code into the alarm panel. NOTE: We recommend using a user code that the user cannot change. If the user code that is programmed into the Receiver module is changed, the Code Encryptor 3 will not disarm the control panel.

The LED will light. When the LED turns off, release the program button. The LED will begin to flash rapidly. Using the keypad, slowly and firmly enter the four-digit user code no other commands.

After the fourth entry the LED will stop flashing. The Code Encryptor will remember this user code in the event of a power failure. To change to a new user code, repeat steps 2 and 3 above. You will then have to add them back into 2.

The LED indicating the remote has been learned. Latest commit. Git stats 67 commits. Failed to load latest commit information. View code. Params : hugoEnc : promptText : " Part of this article is encrypted with password: " inputPlaceholder : " Please input the password " buttonText : " Unlock ".